Details on the DIMO x AutoPi Hardware Miner
The OBD2 port is usually under the front console on the driver’s side of the vehicle, but there can be a lot of variation from car to car. Check out this link to identify where your OBD2 port is.
DIMO does compatibility testing with all vehicles we support. DIMO-approved 3rd party hardware devices are currently passive listeners only. This means that they cannot be used to control your vehicle.
The device has 2 led indicators, Blue and Green. Listed below are the states of those lights
- Blue blinking - This is when the device powers on, it takes 25-30 seconds for the device to fully boot
- Solid Blue - This means the device has fully powered on.
- Breathing Blue, No Green - This means that the device has gone into hibernation mode.
- Blinking Green - A blinking green light means its searching for a network to connect to
- Solid Green - The device has successfully connected to the network either via LTE or WIFI
- Rapidly Flashing Green - This means that the device is updating, this could take 5-20 minutes to finish updating.
As a user, you will sign the data with your wallet and DIMO will validate the signature when data is received. Data is watermarked for third-party consumers.
DIMO is an open source supporter and contributor, building on projects like openDBC, CANserver, and CANBusHack to compile and maintain a library of CAN codes. Want to contribute? Click here.
The device goes into a low-power sleep mode shortly after you stop driving, the device draws negligible amounts of power close to being unplugged so you will not see any vampire battery drain from the device.
No, the device is not always connected. As mentioned above, if the device is in hibernation mode it only uses a tiny amount of power and won’t drain your battery at all. You will need to drive your vehicle to power the device on.
Turning your car on is not currently supported. It is possible to add this functionality for certain vehicles in the future.
DIMO is paying for cellular costs of transmitting data from your vehicle for at least 12 months. The DIMO DAO will decide how ongoing costs will be handled after the initial 12 month period.
DIMO users will receive an allotment of 1GB of data per month. If you go over this allotment the device may not connect to the network.
The data will be saved on the device until you return to an area with cellular connectivity.
Vehicles only come with one OBD2 port, but we have validated in the alpha fleet that OBD-II splitters like this model will work on all cars tested so far.
In the future, DIMO will work to build partnerships with insurance companies so that you can provide them the data they would need to offer discounts (but no other data!).